The study on polymer melt front, gas front and solid layer in filling stage of gas-assisted injection molding

研究成果: 雜誌貢獻文章同行評審

15 引文 斯高帕斯(Scopus)

摘要

The algorithms are developed to predict the polymer melt front, gas front and solid layer in gas-assisted injection molding. The simulation of two-dimensional, transient, non-isothermal and high viscous flow between two parallel plates with the generalized Newtonian fluid is presented in detail. During solidification while an injection mold fills, a solid-liquid interface moves and a two-phase zone exists; an enthalpy model is used to predict this interface in the two-phase flow problem. The model takes into account the three-phase flow including the effects of the gas front, solid layer and polymer melt front.
原文英語
頁(從 - 到)139-148
頁數10
期刊International Communications in Heat and Mass Transfer
28
發行號1
DOIs
出版狀態已發佈 - 一月 2001
對外發佈Yes

ASJC Scopus subject areas

  • Fluid Flow and Transfer Processes
  • Mechanical Engineering

指紋 深入研究「The study on polymer melt front, gas front and solid layer in filling stage of gas-assisted injection molding」主題。共同形成了獨特的指紋。

引用此