Design and fabrication of multiplexer driver for InP-laser arrays with waveguide

Jian Chiun Liou, Cihun Siyong Alex Gong, Cheng Fu Yang, Yen Hsiang Fang

研究成果: 雜誌貢獻文章

摘要

To reduce the noise interference, we designed multiplexer-drive circuit used in InP laser array. This system is the use of D-Filp Flop circuit architecture do digital operations. It controls two adjacent InP laser systems, two InP laser is not functioning at the same time and will not cause interference. In order to investigate the micro-disk laser under the band at 1310 nm, this system using 2 mm × 2 mm InP laser chips bonding through the DVS-BCB to 2 cm × 2 cm hybrid laser processes, including SOI wafer waveguides, processing approach and chip architecture photo investigations. The I–V curve measured under the needle was found operating under current of approximately 30 mA at 1.5 V. The maximum optical power is about 2.2 μW at 40 mA.
原文英語
文章編號97
頁(從 - 到)1-14
頁數14
期刊Optical and Quantum Electronics
48
發行號2
DOIs
出版狀態已發佈 - 二月 1 2016
對外發佈Yes

指紋

laser arrays
Waveguides
waveguides
Fabrication
fabrication
Lasers
lasers
chips
interference
Videodisks
Networks (circuits)
SOI (semiconductors)
needles
Needles
wafers
causes
curves
Processing

ASJC Scopus subject areas

  • Electronic, Optical and Magnetic Materials
  • Atomic and Molecular Physics, and Optics
  • Electrical and Electronic Engineering

引用此文

Design and fabrication of multiplexer driver for InP-laser arrays with waveguide. / Liou, Jian Chiun; Gong, Cihun Siyong Alex; Yang, Cheng Fu; Fang, Yen Hsiang.

於: Optical and Quantum Electronics, 卷 48, 編號 2, 97, 01.02.2016, p. 1-14.

研究成果: 雜誌貢獻文章

Liou, Jian Chiun ; Gong, Cihun Siyong Alex ; Yang, Cheng Fu ; Fang, Yen Hsiang. / Design and fabrication of multiplexer driver for InP-laser arrays with waveguide. 於: Optical and Quantum Electronics. 2016 ; 卷 48, 編號 2. 頁 1-14.
@article{29f3dc3ced3b4b3fbfce7378a1c9ea99,
title = "Design and fabrication of multiplexer driver for InP-laser arrays with waveguide",
abstract = "To reduce the noise interference, we designed multiplexer-drive circuit used in InP laser array. This system is the use of D-Filp Flop circuit architecture do digital operations. It controls two adjacent InP laser systems, two InP laser is not functioning at the same time and will not cause interference. In order to investigate the micro-disk laser under the band at 1310 nm, this system using 2 mm × 2 mm InP laser chips bonding through the DVS-BCB to 2 cm × 2 cm hybrid laser processes, including SOI wafer waveguides, processing approach and chip architecture photo investigations. The I–V curve measured under the needle was found operating under current of approximately 30 mA at 1.5 V. The maximum optical power is about 2.2 μW at 40 mA.",
keywords = "InP laser, Multiplexer, Optical power, SOI, Wavguide",
author = "Liou, {Jian Chiun} and Gong, {Cihun Siyong Alex} and Yang, {Cheng Fu} and Fang, {Yen Hsiang}",
year = "2016",
month = "2",
day = "1",
doi = "10.1007/s11082-016-0401-9",
language = "English",
volume = "48",
pages = "1--14",
journal = "Optical and Quantum Electronics",
issn = "0306-8919",
publisher = "Springer New York",
number = "2",

}

TY - JOUR

T1 - Design and fabrication of multiplexer driver for InP-laser arrays with waveguide

AU - Liou, Jian Chiun

AU - Gong, Cihun Siyong Alex

AU - Yang, Cheng Fu

AU - Fang, Yen Hsiang

PY - 2016/2/1

Y1 - 2016/2/1

N2 - To reduce the noise interference, we designed multiplexer-drive circuit used in InP laser array. This system is the use of D-Filp Flop circuit architecture do digital operations. It controls two adjacent InP laser systems, two InP laser is not functioning at the same time and will not cause interference. In order to investigate the micro-disk laser under the band at 1310 nm, this system using 2 mm × 2 mm InP laser chips bonding through the DVS-BCB to 2 cm × 2 cm hybrid laser processes, including SOI wafer waveguides, processing approach and chip architecture photo investigations. The I–V curve measured under the needle was found operating under current of approximately 30 mA at 1.5 V. The maximum optical power is about 2.2 μW at 40 mA.

AB - To reduce the noise interference, we designed multiplexer-drive circuit used in InP laser array. This system is the use of D-Filp Flop circuit architecture do digital operations. It controls two adjacent InP laser systems, two InP laser is not functioning at the same time and will not cause interference. In order to investigate the micro-disk laser under the band at 1310 nm, this system using 2 mm × 2 mm InP laser chips bonding through the DVS-BCB to 2 cm × 2 cm hybrid laser processes, including SOI wafer waveguides, processing approach and chip architecture photo investigations. The I–V curve measured under the needle was found operating under current of approximately 30 mA at 1.5 V. The maximum optical power is about 2.2 μW at 40 mA.

KW - InP laser

KW - Multiplexer

KW - Optical power

KW - SOI

KW - Wavguide

UR - http://www.scopus.com/inward/record.url?scp=84954309120&partnerID=8YFLogxK

UR - http://www.scopus.com/inward/citedby.url?scp=84954309120&partnerID=8YFLogxK

U2 - 10.1007/s11082-016-0401-9

DO - 10.1007/s11082-016-0401-9

M3 - Article

AN - SCOPUS:84954309120

VL - 48

SP - 1

EP - 14

JO - Optical and Quantum Electronics

JF - Optical and Quantum Electronics

SN - 0306-8919

IS - 2

M1 - 97

ER -