Comparison of the results for semisolid and plastic injection molding process

Y. K. Shen, J. J. Liu, C. T. Chang, C. Y. Chiu

研究成果: 雜誌貢獻文章

31 引文 斯高帕斯(Scopus)

摘要

Understanding the time-dependent flow behavior of semisolid and plastic materials is essential for the injection molding. The 3C (Computer, Communication, Consumer) product is more light, thin, short and small on today. Traditional injection molding uses the plastic for the shell of 3C product. Because the EMI, good heat dissipation etc., the magnesium for the shell of 3C product is more increasing now. The properties of plastic are shear-thinning. The properties of magnesium are shear-thickening and it injects the mold by semisolid form. Therefore, the situation of injection molding between plastic and magnesium is very different. This paper uses the CAE software (MoldFlow) to analysis the result with different materials (ABS, ABS/PC, Mg), different processing parameters (injection temperature, mold temperature, injection pressure, injection time), and different thickness (1.0mm, 0.9mm). In order to obtain the optimum results, the simulation introduces Taguchi method to discuss the influence of each parameter in injection molding.
原文英語
頁(從 - 到)97-105
頁數9
期刊International Communications in Heat and Mass Transfer
29
發行號1
DOIs
出版狀態已發佈 - 一月 2002
對外發佈Yes

ASJC Scopus subject areas

  • Fluid Flow and Transfer Processes
  • Mechanical Engineering

指紋 深入研究「Comparison of the results for semisolid and plastic injection molding process」主題。共同形成了獨特的指紋。

  • 引用此